WPM Logo

Walser

Pistenraupen
Modellbau

EN
DE

Die Cast Models

Each snow cat fan of course owns a couple of die cast models. Here we show some of them and also how a ParkPro can made from the JC PB400. 


Our collection of die cast models includes by the way almost all snow cat models, which have been made so far, including the rare Conrad PB240D.

JC PB400 ParkPro in 1:32

Until December 2019 the Jaegerndorfer PB400 was not available in the ParkPro design, but we made one in 2017. Now the ParkPro is readily available at the PistenBully fan store. Obviously we got them the idea ;-)


The drivers cabin can be unmounted by loosening the screw at the bottom. It is then carefully masked for the airbrushing with satin black, as shown at the lower left. The mirror mounts and handle bars are also painted black, which is best done with a fine brush.


The printed white logos can be removed with some patience with a cotton swap and ethanol (alcohol), or very carefully with a cloth rag moistened with lacquer thinner. Better try beforehand on a non visible part that the red paint is not removed as well.





The decals were made by us and they are available at Pistenking. These must be cut very close to the print, as seen to the left. They are put into water for about 10 seconds and can then easily be slided on to the body. They work the same as the decals from plastic kits.


The ParkPro also features logo and text on the roof, which are also included in the decals set.


As the ParkPro has a lever steering on the left arm rest the steering column has to be cut away. For a truly scale look the cutting angle cylinder of the blade has to be attached to the rear of the pushing frame instead to the chassis tub. This is not so easily done and therefore we didn't do it so far.

JC PB400 in ParkPro design

JC PistenBully 400 in 1:32

The company Jägerndorfer released two beautiful models of the PB400 at Christmas 2012, with and without a winch. Of course we had to get them immediately. This was reason enough for Eric to do a photo session in natural surroundings.





PistenBully 600 in 1:43

The PistenBully shop features beautiful models of the PB600 with and without a winch and in different scales. Of course we have them. Eric did a small photo session in natural surroundings.





Copyright © 2020 Walser Pistenraupenmodellbau 


Copyright © 2019 Walser Pistenraupenmodellbau 

Diese Seite verwendet Cookies. Sie stimmen der Verwendung von Cookies durch Anklicken von “OK” zu. Nähere Informationen finden Sie in unseren Datenschutzbestimmungen.
This page is using Cookies. You are permitting the use of cookies by clicking on “OK”. More information can be found at our Privacy Protection.

OK